General Maintenance; Declaration Of Conformity - Felisatti SDF4.8R Bedienungsanleitung

SPINDLE LOCK
The screwdriver spindle is locked when the On/Off switch is
not pressed.
This enables screws to be screwed in, even when the battery
is empty.
GRIP ZONE (SDF3.6RLi)
Soft grip reduces the danger of slipping and thereby improves
the grip on the tool and handing.
At the same time, The rubber coating achieves a vibration-
reducing effect.
MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use
of any other parts may create a hazard or cause product
damage.
WARNING
Always wear safety goggles or safety glasses with side
shields during product operation or when blowing dust. If
operation is dusty, also wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic
parts. Chemicals can damage, weaken or destroy plastic
which may result in serious personal injury.
Do not open the battery yourself. There is a danger of short
circuit.
All parts should be replaced at an Authorizd Service Center.
6
Do not dispose of electric tools
in the household waste!
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances
and its translation into national law, used electric
tools must be collected separately and recycled in
an ecologically desirable way.
DECLARATION OF
CONFORMITY
We hereby declare, under our sole
responsibility, that the FELISATTI
brand products described in this
manual comply with the following
standards or standard documents:
EN60745-1:2009,
2-2:2010,
EN55014-2:1997+A1+A2, EN61000-
3-2:2006+A1+A2, EN61000-3-3:2008
in accordance with EU Directives
2006/42/EC, 2006/95/EC, 2004/108/
EC, 2002/95//EC, 2002/96/EC
We reserve the right to make technical changes 06/2011
EN60745-
EN5014-1:2006+A1,
Francisco Ruis
Technical director