Maintenance And Care; Warranty; Declaration Of Conformity - Felisatti SDF8/700ER Bedienungsanleitung

BELT CLIP
Using the clip, the machine can be attached to the belt.
This way, the user can have his hands free as well as easy
access to the machine.
ACCESSORIES
Accessories and their corresponding order number can be
found in our catalogues.

MAINTENANCE AND CARE

WARNING! Always unplug the machine before carrying out
work on it.
- Inspect the mounting screws: Regularly inspect all the
mounting screws and ensure they are firmly tightened.
Should any screw be loose, tighten it immediately. Failure to
do so could put you at serious risk.
- Motor maintenance: Always take the greatest care over this
and make sure that the motor winding is not damaged and
does not become wet with oil or water.
- The vents should always be kept clean and free of
obstacles.
- Clean the machine thoroughly after each use. Blast the
motor regularly with compressed air.
- Check that the mains lead is in good condition. If it is not,
take it to an Official Service Centre to have it replaced.
- Brush replacement: Brushes must be replaced when length
reaches 8 mm or less. To do so, please contact an authorized
after sales service center. We recommend that every other
time you take a tool to an after sales service centre for brush
replacement, you also order a general service (cleaning and
lubrication).
- Use only Felisatti accessories and spares. Parts the
changing of which is not covered in this instruction
manual, should be replaced in a Felisatti Official Service
Centre (See Warranty/Official Service Centre address
leaflet).

WARRANTY

See general warranty conditions printed on the attached
sheet.
Do not dispose of electric tools
in the household waste!
In accordance with European Directive 2002/96/EC
relating to old electrical and electronic appliances
and its translation into national law, used electric
tools must be collected separately and recycled in
an ecologically desirable way.
DECLARATION OF
CONFORMITY
We hereby declare, under our sole
responsibility, that the FELISATTI
brand products described in this
manual comply with the following
standards or standard documents:
EN60745-1:2009,
2-2:2003,
EN55014-2:1997�A1�A2, EN61000-
3-2:2006�A1�A2, EN61000-3-3:2008
in accordance with EU Directives
2006/42/EC, 2006/95/EC, 2004/108/
EC, 2002/95//EC, 2002/96/EC
Jordi Carbonell
We reserve the right to make technical changes 06/011
EN60745-
EN5014-1:2006�A1, EN5014-1:2006�A1, 5014-1:2006�A1,
Santiago Lopes
5