Troubleshooting - Team Kalorik TKG SKV 1004 N Bedienungsanleitung

TROUBLESHOOTING

Problem
The vacuum
cleaner does
not turn on
The vacuum
cleaner is not
charging
The suction
power is
decreasing
Vacuum
cleaner is
overheating
The air coming
out of the
vacuum
cleaner smells
bad
The battery/
charging
indicator light
is blinking
The brush does
not turn
anymore
Possible cause
The vacuum cleaner
has not been
charged
The power switch is
not turned on
The power cord is
damaged
The crevice tools or
extension hose may
be blocked
The water in the
water tank is very
dirty
The filter is dirty
The filter is dirty
The filter is dirty
The filter is not dry
The vacuum cleaner
is out of power
The brush is dirty
Solution
Make sure the vacuum cleaner
has been fully charged before
first time use or if it has not
been used for a long time
Make sure the power switch of
the main power supply is
turned on
Do not use a damaged power
cord. Please contact the
customer service center
Check for any blockages and
clear them
Regularly replace the water in
the reservoir by clean water
and empty the water tank after
each use
Check with the supplier for
replacement parts
Check the filter and clean off
any dirt
Check the filter and clean off
any dirt
Make sure the filter is dry before
inserting it back into the hand
vacuum cleaner. Replace the
water with clean water if
needed.
Recharge the vacuum cleaner
to its full capacity. The light will
stop blinking.
Clean the brush