Team Kalorik TKG SKV 1004 N Bedienungsanleitung Seite 11

ASSEMBLING THE VACUUM CLEANER
• Unpack the device and all accessories.
• Make sure that all parts mentioned in the manual are present and undamaged.
• Carefully secure the handle (8) to the main unit. To do this, carefully pull on the supplied
locking screw (9) (Ill. 4, Fig. 1).
• Insert the hand vacuum cleaner (4) into the main unit. For this, the device must always be
switched off. Pay attention to the "click" sound when snapping in (Ill. 4, Fig. 3). Make sure that
there are no substances between the contacts of the handpiece (4) and the main unit,
• Charge the battery in the following situations:
Before first use; in this case, the battery must be fully charged (6-8 hours).
-
After a long period without use. (For optimal battery life, we recommend charging
-
the device at least every three months.)
• To load, the hand vacuum cleaner (4) must be inserted in the main unit (Ill. 5, Fig. 4).
•
Plug the mains adapter of the charging cable (14) into a socket (Ill. 5, Fig. 5). Connect the
charging cable (14) to the charging port (10) of the main unit (Ill. 5,Fig. 6). Make sure that the
contacts on the charging cable and the vacuum cleaner are clean. If necessary, remove the
charging cable and clean the connectors.
•
The charge indicator (4) turns red while the battery is charging (Ill. 5, Fig. 7) and turns to blue
when the battery is fully charged.
•
Both the charging cable and the vacuum cleaner may become warm while charging. This is
completely normal.
•
If you use the hand vacuum cleaner for a long period of time, the batteries can also warm up
here. This is also completely normal.
Note: For best performance, it is recommended to charge the vacuum cleaner after each use.
USE
• DANGER! Do not use the product while it is charging.
• DANGER! Never touch the rotating parts of the floor brush during operation.
•
Remove the water tank (Ill. 6) by first using the switch (11) and opening the water tank casing
(12). Remove the water tank (3) using the handle (2). Open the locking clips (5) and remove
the lid (4).
•
Pour clean water in the tank, up to the mark.
• Close the lid (4) again and put the water tank (3) back into the main unit.
• Press the on / off switch (1) on the handle (8) of the main unit to switch on the device. Use the
ECO switch (2) to change the speed levels.
Note:
1. During cleaning, foam may form in the water tank. The performance of the device is not
affected by slight foaming.
2. Detergent, soap powder, bleach and the like MUST NOT be added to the water tank.
•
Press the on / off button (1) again to switch off the appliance.
•
During short breaks, you can stop the vacuum cleaner by tilting the appliance slightly
forward.
Note: Make sure that the vacuum cleaner is on a level, non-slip surface before releasing it, to
prevent it from falling over and causing possible damage to the unit or floor.