Silvercrest SON 90 A1 Bedienungsanleitung Seite 11

3. Thread the yarn into the thread guide in that you pull the thread down
until it slips under the thread guide (2) (Fig. 16).
4. Firmly hold the yarn with your fingers, guide it between and through
the discs of the thread tension selector z and then pull it down (3)
(Fig. 17).
Note:
The yarn must lie correctly between the two discs of the thread tension
selector z.
5. Thread the yarn in the looper area as per the red markings (Fig. 18).
6. Pull the thread from back to front through the upper looper o.
7. Pull around 10 cm of thread through the looper and place it behind
the stitch plate e.
Fig. 17
Fig. 18
- 9 -
Fig. 16