LENCO PDR-19 Benutzerhandbuch Seite 9

Press the Enter button and the display will show "Factory Reset?". Press the Next button until the word
"YES" is flashing.
Press the Enter button again, this will reset the radio.
Snooze Function
When the alarm sounds, press the Enter/Snooze button to delay the alarm for another 9 mins. The
radio will go to Standby mode.
You can press Power/Mode button to stop the Snooze function and go to the operation mode before
the alarms rings.
FAQs
Problem
No sound
Buttons are not working
FM: Static sound
DAB: Burbling/intermittent
cut ‐ out
Sound is destorted
Desired station not found
Display shows "No Service"
Display is blank
Specifications
Power supply
Frequency rangs
Output connector
Aerial
Power supply adaptor (For EU only)
Manufacture
Input
Output
Mode Number
Use only original AC adaptor
Use only the power supply listed on the user
instructions
Play Time
Your radio has a play time of around 3‐5 hours. This is dependant on signal strength and volume
selection of the radio
Solution
The station is not tuned in. Fine tune the station.
The volume is set to a low position. Increase the volume.
Headphones may be connected. Disconnect the headphones.
Turn off the unit and turn on after a few seconds.
Signal reception is too low. Adjust the aerial or move the unit to a
stronger signal location.
Rescan stations.
The volume is too high. Adjust the volume control.
Weak signal. Use the manual tune function.
There is no DAB coverage in your area, or poor receiption. Adjust the
position of the aerial, or move the unit to a stronger signal location.
This may occur if the broadcaster changes the label of a service or
removes a label while tuned. The radio will try to retune or perform a
scan.
Built‐in battery
FM 87.5‐108MHz
DAB 174‐240 MHz
3.5mm earphone socket
Telescopic antenna
Shenzhen Adition Audio Science &Technology Co.Ltd
AC 100‐240V~50/60Hz,0.15A Max
DC 5V/1A
AD050501000EUU
9