Faults - Speck Zismatic 40/10 WE Originalbetriebsanleitung

Faults

6 Faults
Problem: Pump doesn't run.
Possible cause
No voltage.
Thermal motor protection
triggered.
Problem: No flow rate; motor turns.
Possible cause
Insufficient fluid level.
Problem: Pump stops automatically.
Possible cause
Voltage error.
Thermal motor protection
triggered.
Insufficient fluid level.
Problem: Too low a flow rate in the pump.
Possible cause
Insufficient fluid level.
Strainer basket is clogged.
Wear to the hydraulic system.
18 EN
Solution
Check the fuse and other

protective devices.
 Wait for the motor
winding to cool down and
the motor protection to
turn back on.
Solution
 Ensure the pump is
completely submerged.
Solution
 Ensure that the voltage
on the name plate
corresponds to the
voltage indicated.
 Wait for the motor
winding to cool down and
the motor protection to
turn back on.
 Close tap to reduce the
pump's flow volume.
Solution
 Close tap to reduce the
pump's flow volume.
 Clean the strainer basket.
 Contact customer
services.
06|2019