Electrical Connection - Speck Zismatic 40/10 WE Originalbetriebsanleitung

Installation
4.4

Electrical connection

WARNING
Risk of electric shock due to incorrect connections!
 Electrical connections must always be carried out by
authorised specialists.
 Observe VDE and utility company regulations.
Install a disconnecting device with at least a 3 mm contact

gap per pole to interrupt the power supply.
Protect power supply with a ground fault circuit interrupter,

nominal residual current I
 Only use suitable pipe types according to regional
regulations.
 Adjust minimum diameter of the electrical pipes to
accommodate the motor output and pipe length.
 If hazardous situations can occur, provide an emergency off
switch according to DIN EN 809. The builder/operator must
make a decision according to this standard.
Fig. 4
16 EN
≤ 30 mA.
FN
06|2019