Hitachi RAK-18QH8S W Bedienungsanleitung Seite 21

2. Washable Front Panel
Remove the front panel and wash with clean
●
water.
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly
with clean water.
When front panel is not removed, wipe it with
●
a soft dry cloth. Wipe the remote controller
thoroughly with a soft dry cloth.
Wipe the water thoroughly.
●
If water remains at indicators or signal receiver
of indoor unit, it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands
to detach and attach it.
Removing the Front Panel
When the front panel is fully opened with
●
both hands, push the right arm to the inside
to release it, and while closing the front panel
slightly, put it out forward.
CAUTION
Do not splash or direct water to the body of the unit when cleaning it as
●
this may cause short circuit.
Never use hot water (above 40°C), benzine, gasoline, acid, thinner or a
●
brush, because they will damage the plastic surface and the coating.
Arm
Flange
●
– 18 –
Attaching the Front Panel
Projection
Hole
Move the projections of the left and right arms
into the Flanges in the unit and securely insert
them into the holes.