Axis Q60 Serie Installationsanleitung Seite 19

AXIS Q60 Series
Hard Ceiling Mount
1. Prepare the ceiling for installation of the mounting plate. The supplied drill template
can be used to position the holes. Make sure to use drill bits, screws and plugs that
are appropriate for the material.
2. Install the mounting plate. The arrow on the mounting plate will align with the logotype
on the camera.
1
Mounting plate
2
Safety wire
3. Loosen the camera base lid screws and remove the camera base lid.
4. Secure the camera using the supplied safety wire.
5. Route and connect the network cable and the multi-connector cable (sold separately), if
applicable, to the camera.
NOTICE NOTICE NOTICE
• Be careful not to damage the cables when connecting them.
• Make sure that the foam gasket holes are aligned with the cable tracks and, if applicable,
remove the cut-out piece for the multi-connector cable from the foam gasket.
1
Cable holders
2
Multi-connector cable (sold separately)
3
Network cable (not included)
2
19
1
1
2
3