Axis Q60 Serie Installationsanleitung Seite 21

AXIS Q60 Series
NOTICE
NOTICE NOTICE
• Be careful not to damage the cables when connecting them.
• Make sure that the foam gasket holes are aligned with the cable tracks and, if applicable,
remove the cut-out piece for the multi-connector cable from the foam gasket.
1
Cable holders
2
Multi-connector cable (sold separately)
3
Network cable (not included)
7. Turn the cable holders to keep the cables in place.
8. Put the camera base lid back in its original position and tighten the screws (torque
1.5 Nm).
9. Secure the camera using the supplied safety wire.
21
1
2
3