H-tronic TSM 125 Bedienungsanleitung Seite 23

– Before opening the device, please disconnect it from the mains and/or make
sure that it is not connected to an electrical current.
– Tools may only be used if the device is disconnected from the mains.
– All connecting cables should regularly be inspected for any damages on the
insulation.
– Should any damages be found, disconnect the device immediately from the
mains and repair or exchange it.
Should there be any open questions on the installation, the devices connected,
the functions, the maintenance, the safety or any other point concerning this
device, please contact a specialist or a qualified person.
Before installing and using this device, please make sure that it and the attached
devices are suitable and compatible. In no event will liabilities be taken for
consequential or incidental direct or indirect damages resulting from improper
use or incorrect installation of the device.
MALFUNCTION
Only use the device if it is functioning without disturbance. If there is any
malfunction, switch off the device immediately and consult a specialist. The
device may only be reinstalled after it has been checked thoroughly. Signs of
malfunction are if:
– The device is visibly damaged.
– The device is malfunctioning.
– Attached cables or the housing has become loose.
Repairs may only be done by a qualified person or a specialist using original
components and parts. There is the danger of electrocution.
4. MOUNTING
Connect a stabilized and filtered DC voltage of 12 V (10 –15 V) to the two screw
terminals, designated with „12 V DC" using the correct polarity. If an AC higher
than 25 V or a DC higher than 60 V is set at the built-in relay you must provide
that it must not be touched – or the device must be operated in a housing in
which the unit can not be touched. In this case the device may only be installed
or operated by a specialistt or an electrician. Hereby please notice the valid
VDE regulations.
Temperature Switch TSM 125 | 23