Key; Installation; Tools - Gestra NRS 1-9 Betriebsanleitung

Installation

NRS 19
On supporting rail
. Snap switching controller onto supporting rail.
. Loosen cover screws A and unplug cover B from its base C.
. Select cable entry D and remove corresponding seal.
On mounting panel
. Loosen cover screws A and unplug cover B from its base C.
. Unscrew mounting clip E.
. Drill the hole F marked in the base to 4. mm diameter.
4. Select cable entry D and remove corresponding seal.
5. Fasten base with two screws M4 onto mounting panel.

Tools

Screwdriver (5.5/00)
n

Key

A
Cover screws
B
Cover
C
Base
F
Hole for wall mounting
H
Mounting clip
I
Support rail TS 5 x 5 to DIN EN 500-5

