Measuring Method; Decimal Point; Temperature Unit - Kübler CODIX 531 Bedienungsanleitung

5.4 Programmng the adjustable parameters
5.4.1 Input signal type
Range
Selection in the menu
Pt100 probe
Ni100 probe

5.4.2 Measuring method

Measuring method
Selection in the menu
2 wires; please note
See point 5.4.2.1 opposite!
3 wires
4 wires

5.4.3 Decimal point

Decimal point
Selection in the menu
Resolution 0,1 °C/0,1 °F
Resolution 1 °C/1 °F
5.4.5 Correction value
Inputting a correction value allows acting upon the
displayed result. These correction values may be
Setting the correction value
Selection in the menu
...
16
Note :
The fields with a grey background
contain the factory-set default
values.
5.4.2.1 Line resistivity
If you selected the 2-wire measuring method in 5.4.2,
the display shows
Input here the line resistivity of your 2-wire probe for
long connection cables. If the resistivity value input
here is wrong, the displayed result will not be correct.

5.4.4 Temperature unit

Selection in the menu
positive or negative. The input is always made with one
decimal place.
...
...
Unit
Display in °C
Display in °F
Correction value in 0,1 °C/0,1 °F,
depending on the unit selected