Optional Accessories - Berner BCLL BASIC Bedienungsanleitung/Sicherheitshinweise

ENGLISH
• Reposition the detector out of the intense light or shade the sensor
window (25) to resume normal operation.

Optional Accessories

USING THE LASER WITH ACCESSORIES (FIG. 1 INSET)
The laser is equipped with a 1/4" × 20 female thread (11) on the bottom of
the unit.
This thread is to accommodate current or future Berner accessories. Only
use Berner accessories specifi ed for use with this product. Follow the
directions included with the accessory.
Consult your Berner Partner for further information on the appropriate
accessories.
MAINTENANCE
Your Berner power tool has been designed to operate over a long period
of time with a minimum of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Field Calibration Check (fi g. H–J)
The fi eld calibration check must be performed securely and accurately to
make a correct diagnosis. Whenever an error is registered, have the tool
serviced by a qualifi ed repair agent.
WARNING: The conditions of the area are indicative of the
results presented. If the practice diff ers from these conditions,
the measurements have to be adjusted accordingly.
SCAN CHECK (FIG. H)
• Place the tool in an area between two vertical surfaces that are at least
9 m apart.
Mount the tool exactly midways to the wall.
• Position the tool at an angle of 45° to the left.
• Switch on the horizontal laser beam.
• Mark the centre of the laser beam exactly midways on the opposite wall.
• Switch off the tool and rotate it 90° clockwise.
• Switch on the horizontal laser beam.
• Mark the centre of the laser beam exactly midways on the opposite wall.
22