End Of Operation - diversey TASKI swingo 755B Power Bedienungsanleitung

End of operation

• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
Variant: Automatic brush lowering (Option 1255B)
• Press the Brush drive button ON/
OFF.
The display lights up and the brush
unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
Variant: Foot pedal
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Lift the squeegee.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but-
ton.
The display lights up; the suction en-
gine stops.
• Switch off the machine.
Caution:
The machine must now be emptied and cleaned.
Switch off the machine (main switch) and discon-
nect the battery disconnection socket before begin-
ning with the following steps.
Removing and cleaning the squeegee
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc-
tion nozzle is released and can be re-
moved from the suction nozzle
holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure optimal suc-
tion results!
Empty and clean the recovery tank and fresh
water tank
Notice:
Drain water or cleaning solution must be disposed
of in compliance with the national regulations.
Notice:
When draining the recovery tank, the regulations of
the detergent supplier regarding personal protec-
tive equipment of the cleaning solution manufactur-
er must be observed.
Proceed as follows:
• Take the drain hose out of the holder.
• Open the red or blue cover at the level of the handle, lower
the end of the hose slowly and empty the recovery or fresh
water tank.
77