Electrical Connection Of The Hood - Sirius S-DD11-L Bedienungsanleitung Mit Montageanweisungen

12). The replacement of the charcoal filters has
to be carried out accordingly to the effective use
of the Downdraft, and in any case at least once
every 6 months.
ELECTRICAL CONNECTION
ELECTRICAL CONNECTION ELECTRICAL CONNECTION
WARNING
OF THE COOKER HOOD
OF THE COOKER HOOD OF THE COOKER HOOD
After having replaced the filters, reinstall the
front stainless steel pan'el, otherwise the
WARNING
WARNING WARNING
Downdraft is not enabled to function.
Place the metal box containing the elec-
Place the metal box containing the elec- Place the metal box containing the elec-
tronic components at a distance of no less
tronic components at a distance of no less tronic components at a distance of no less
than 65 cm from gas-operated cook tops or
than 65 cm from gas-operated cook tops or than 65 cm from gas-operated cook tops or
in any case, 65 cm from the suctioning sur-
ELECTRICAL CONNECTION
in any case, 65 cm from the suctioning sur- in any case, 65 cm from the suctioning sur-
face of the cookerhood.
face of the cookerhood. face of the cookerhood.
OF THE COOKER HOOD
S-DD2-L FLUSH TOP
NOTA
WARNING
NOTA NOTA
We recommend installing the metal box
Place the metal box containing the elec-
ELECTRICAL CONNECTION
We recommend installing the metal box We recommend installing the metal box
containing the electronic components at
tronic components at a distance of no less
containing the electronic components at containing the electronic components at
OF THE COOKER HOOD
least 10 cm above floor level and at a suita-
than 65 cm from gas-operated cook tops or
least 10 cm above floor level and at a suita- least 10 cm above floor level and at a suita-
ble distance from all heat sources (e.g. oven
in any case, 65 cm from the suctioning sur-
ble distance from all heat sources (e.g. oven ble distance from all heat sources (e.g. oven
WARNING
sides or cook top).
face of the cookerhood.
sides or cook top). sides or cook top).
Place the metal box containing the elec-
tronic components at a distance of no less
NOTA
NOTE
CAUTION
than 65 cm from gas-operated cook tops or
CAUTION CAUTION
We recommend installing the metal box
in any case, 65 cm from the suctioning sur-
This appliance is fitted with an H05 VVF 3
This appliance is fitted with an H05 VVF 3 This appliance is fitted with an H05 VVF 3
containing the electronic components at
face of the cookerhood.
conductor, 0.75 mm2 (neutral, phase, and
conductor, 0.75 mm2 (neutral, phase, and conductor, 0.75 mm2 (neutral, phase, and
least 10 cm above floor level and at a suita-
ground) power cord.
ground) power cord. ground) power cord.
ble distance from all heat sources (e.g. oven
This can be connected up to a 220 - 240 V
NOTA
This can be connected up to a 220 - 240 V This can be connected up to a 220 - 240 V
sides or cook top).
mono-phase electrical network through a
mono-phase electrical network through a mono-phase electrical network through a
We recommend installing the metal box
CEI 60083 approved power socket, which
CEI 60083 approved power socket, which CEI 60083 approved power socket, which
containing the electronic components at
must remain accessible after installation, in
must remain accessible after installation, in must remain accessible after installation, in
least 10 cm above floor level and at a suita- CAUTION
compliance with installation regulations.
compliance with installation regulations. compliance with installation regulations.
ble distance from all heat sources (e.g. oven
We decline any responsibility in case of ac-
This appliance is fitted with an H05 VVF 3
We decline any responsibility in case of ac- We decline any responsibility in case of ac-
sides or cook top).
cidents caused by a lack of ground connec-
conductor, 0.75 mm2 (neutral, phase, and
cidents caused by a lack of ground connec- cidents caused by a lack of ground connec-
tion or incorrect ground connection. The
ground) power cord.
tion or incorrect ground connection. The tion or incorrect ground connection. The
appliance must be fed through a differen-
This can be connected up to a 220 - 240 V
appliance must be fed through a differen- appliance must be fed through a differen-
CAUTION
tial protection device (RCD), with a nominal
mono-phase electrical network through a
tial protection device (RCD), with a nominal tial protection device (RCD), with a nominal
residual current not exceeding 30mA. If the
CEI 60083 approved power socket, which
This appliance is fitted with an H05 VVF 3
residual current not exceeding 30mA. If the residual current not exceeding 30mA. If the
power cord is damaged, call the after-sales
must remain accessible after installation, in
conductor, 0.75 mm2 (neutral, phase, and
power cord is damaged, call the after-sales power cord is damaged, call the after-sales
service to avoid any risk.
compliance with installation regulations.
ground) power cord.
service to avoid any risk. service to avoid any risk.
We decline any responsibility in case of ac-
This can be connected up to a 220 - 240 V
cidents caused by a lack of ground connec-
mono-phase electrical network through a
WARNING
tion or incorrect ground connection. The
CEI 60083 approved power socket, which
WARNING WARNING
appliance must be fed through a differen-
must remain accessible after installation, in
The downdraft connection to the electrical
The downdraft connection to the electrical The downdraft connection to the electrical
tial protection device (RCD), with a nominal
compliance with installation regulations.
network must be carried out only by profes-
network must be carried out only by profes- network must be carried out only by profes-
residual current not exceeding 30mA. If the
We decline any responsibility in case of ac-
sional and qualified technicians.
sional and qualified technicians. sional and qualified technicians.
power cord is damaged, call the after-sales
cidents caused by a lack of ground connec-
The downdraft must be connected to a
The downdraft must be connected to a The downdraft must be connected to a
service to avoid any risk.
tion or incorrect ground connection. The
properly installed and suitable electrical
properly installed and suitable electrical properly installed and suitable electrical
appliance must be fed through a differen-
network.
network. network.
tial protection device (RCD), with a nominal
The electrical system must comply with
The electrical system must comply with The electrical system must comply with
residual current not exceeding 30mA. If the WARNING
VDE0100 standard.
VDE0100 standard. VDE0100 standard.
power cord is damaged, call the after-sales
The downdraft connection to the electrical
service to avoid any risk.
network must be carried out only by profes-
S-DD2-L FLUSH TOP
sional and qualified technicians.
S-DD2-L FLUSH TOP S-DD2-L FLUSH TOP
The downdraft must be connected to a
residual current not exceeding 30mA. If the
power cord is damaged, call the after-sales
EN
EN EN service to avoid any risk.
WARNING
DANGER
The downdraft connection to the electrical
If the cooker hood presents any anomaly,
If the cooker hood presents any anomaly, If the cooker hood presents any anomaly,
network must be carried out only by profes-
disconnect the appliance or remove the
disconnect the appliance or remove the disconnect the appliance or remove the
sional and qualified technicians.
fuse corresponding to the appliance power
fuse corresponding to the appliance power fuse corresponding to the appliance power
The downdraft must be connected to a
disconnecting line.
EN
disconnecting line. disconnecting line.
properly installed and suitable electrical
network.
If the appliance has no plug or if the plug is not
If the appliance has no plug or if the plug is not If the appliance has no plug or if the plug is not
The electrical system must comply with
easily accessible, then a device needs to be fit-
easily accessible, then a device needs to be fit- easily accessible, then a device needs to be fit-
VDE0100 standard.
ted to cut it off from the electric network; this
ted to cut it off from the electric network; this ted to cut it off from the electric network; this
device must have an opening distance between
EN
If the cooker hood presents any anomaly,
device must have an opening distance between device must have an opening distance between
contacts on all poles of at least 3 mm.
disconnect the appliance or remove the
contacts on all poles of at least 3 mm. contacts on all poles of at least 3 mm.
S-DD2-L FLUSH TOP
fuse corresponding to the appliance power
disconnecting line.
ELECTRICAL CONNECTION
If the appliance has no plug or if the plug is not
If the cooker hood presents any anomaly,
ELECTRICAL CONNECTION ELECTRICAL CONNECTION
easily accessible, then a device needs to be fit-
disconnect the appliance or remove the
ted to cut it off from the electric network; this
fuse corresponding to the appliance power
device must have an opening distance between
disconnecting line.
This appliance complies with the European
contacts on all poles of at least 3 mm.
This appliance complies with the European This appliance complies with the European
Directives 2006/95/EC (Low Voltage Direc-
If the appliance has no plug or if the plug is not
Directives 2006/95/EC (Low Voltage Direc- Directives 2006/95/EC (Low Voltage Direc-
tive) and 2004/108/EC (Electromagnetic
easily accessible, then a device needs to be fit-
tive) and 2004/108/EC (Electromagnetic tive) and 2004/108/EC (Electromagnetic
Compatibility).
ted to cut it off from the electric network; this
Compatibility). Compatibility).
ELECTRICAL CONNECTION
device must have an opening distance between
contacts on all poles of at least 3 mm.
While installing the appliance and carrying main-
While installing the appliance and carrying main- While installing the appliance and carrying main-
tenance operation, make sure it is disconnected
tenance operation, make sure it is disconnected tenance operation, make sure it is disconnected
from the electrical network or the fuses are cut
This appliance complies with the European
from the electrical network or the fuses are cut from the electrical network or the fuses are cut
out or removed.
Directives 2006/95/EC (Low Voltage Direc-
ELECTRICAL CONNECTION
out or removed. out or removed.
Check that:
tive) and 2004/108/EC (Electromagnetic
Check that: Check that:
Compatibility).
• Power is enou h
• Power is enou h • Power is enou h
• eeder lines mains are in ood condi-
This appliance complies with the European • eeder lines mains are in ood condi- • eeder lines mains are in ood condi-
tions.
While installing the appliance and carrying main-
Directives 2006/95/EC (Low Voltage Direc- tions. tions.
• he cables diameter complies with instal-
tenance operation, make sure it is disconnected
tive) and 2004/108/EC (Electromagnetic • he cables diameter complies with instal- • he cables diameter complies with instal-
lation regulations.
from the electrical network or the fuses are cut
Compatibility). lation regulations. lation regulations.
out or removed.
Check that:
While installing the appliance and carrying main-
• Power is enou h
tenance operation, make sure it is disconnected
• eeder lines mains are in ood condi-
from the electrical network or the fuses are cut
tions.
out or removed.
• he cables diameter complies with instal-
Check that:
lation regulations.
• Power is enou h
• eeder lines mains are in ood condi-
tions.
• he cables diameter complies with instal-
lation regulations.
DANGER DANGER
DANGER
DANGER
NOTA
NOTA NOTA
NOTA
NOTA
NOTE
19
19 19