Maintenance; Optional Accessories - Makita DTS131 Bedienungsanleitung

Standard bolt
N m
20
(kgf cm)
(204)
15
(153)
10
(102)
5
(51)
0
Fastening time (S)
015298
High tensile bolt
N m
20
(kgf cm)
(204)
15
(153)
10
(102)
5
(51)
0
Fastening time (S)
015299
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
Choose a proper impact force and carefully adjust
•
pressure on the switch trigger so that the screw is
not damaged.
Hold the tool pointed straight at the screw.
•
For tightening bolt, select the soft or T mode
•
impact force grade.
If the impact force is too strong you tighten the
•
screw for a time longer than shown in the figures,
the screw or the point of the driver bit may be
overstressed, stripped, damaged, etc. Before
starting your job, always perform a test operation
to determine the proper fastening time for your
screw.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
M8
M8
M6
M6
1.0 2.0
M6
M6
1.0 2.0
1. When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
2. Driver bit or socket bit
Failure to use the correct size driver bit or socket
bit will cause a reduction in the fastening torque.
3. Bolt
Even though the torque coefficient and the class
•
of bolt are the same, the proper fastening torque
will differ according to the diameter of bolt.
Even though the diameters of bolts are the
•
same, the proper fastening torque will differ
according to the torque coefficient, the class
of bolt and the bolt length.
4. The manner of holding the tool or the material of
driving position to be fastened will affect the torque.
5. Operating the tool at low speed will cause a
reduction in the fastening torque.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance except for the
following troubleshooting related to the light.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Screw bits
•
Socket bits
•
Hook
•
Plastic carrying case
•
Makita genuine battery and charger
•
Bit-piece
•
Battery protector
•
Tool hanger
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
9
or attachments
Only use accessory or
are