Before First Use - Moulinex DJ905 Fresh Express Cube & Stick Bedienungsanleitung

• Never operate the appliance while empty.
• Any intervention other than cleaning and usual maintenance by the customer must be carried out by an approved service
centre.
• Do not immerse the appliance, power cord or plug in water or any other liquid.
• The power cord must never be left near or in contact with the hot parts of your appliance, near a source of heat or on a sharp
edge.
• For your safety, only use accessories and spare parts that correspond to your appliance, sold by an approved service centre.
• For your safety, this appliance complies with applicable standards and laws:
- Low Voltage Directive
- Electromagnetic Compatibility
- Environment
- Materials in contact with foodstuffs.
DESCRIPTION
A - Motor unit
B - Removable protector tray (transparent piece)
B1 - Residual food collector
C - Lid
C1 - Start/Stop button
C2 - Feed tube
D - Pusher

BEFORE FIRST USE

• Clean the accessories (blade cartridges, lid, pusher, and removable protector tray) with warm water and washing
up liquid. Rinse and dry them carefully.
WARNING: The blade cartridges are extremely sharp, handle them with care and always hold by the plastic
part. (Fig. 1)
USE
Place the removable protector tray (transparent piece) on top of the appliance (Fig. 2). The protector tray will
keep the appliance from becoming dirty and will allow for easier cleaning.
WARNING: the appliance cannot be operated without the protector tray (B ) in place.
• Select the blade cartridge that corresponds to the desired use. The appliance will automatically set the speed
appropriate for the selected blade cartridge.
-For Thin slicing, Fine Grating and Coarse Grating blade cartridges (E1, E2, E3), place the blade
cartridge on the removable protection tray by placing the blade cartridge stem towards the back
of the appliance (Fig. 3.a).
-For the Cube cartridge and Stick/Fries blade cartridge (E4, E5), positon the cartridge with the
stem towards the back of the appliance (Fig. 3.b).
• Place the lid on the whole appliance and lock it by sliding the lid as shown in (Fig. 4).
WARNING: If the lid is not locked properly, the appliance will not operate.
• Plug in the appliance and place a container under the exit spout (Fig. 5).
• Firmly press the Start/Stop button (Fig. 5).
• Prepare the food ingredients and cut them to fit the feed tube. Insert the food into the feed tube (Fig. 5)
and push them down with the pusher (Fig. 6).
• To change the blade cartridge, unlock the lid by sliding it towards the motor unit and remove the blade
cartridge (Fig. 7). It is best to clean the appliance in between each use.
• Your appliance is equipped with a Start/Stop button (C1). For continuous functioning, keep the button
pressed.
E - Blade cartridges
E1 - Thin slicer (green)
E2 - Fine grating (orange)
E3 - Coarse grating (red)
E4- Cubes (grey)
E5 - Sticks/French Fries (yellow)
F - Cleaning brush
G - Blade cartridge/brush storage container
7