Exciter Oil Change Zi-Rpe60C; Exciter Oil Change Zi-Rpe90C; Changing The Engine Oil; Checking The Clutch - Zipper Maschinen ZI-RPE60C Betriebsanleitung

17.2.1

Exciter oil change ZI-RPE60C

17.2.2 Exciter oil change ZI-RPE90C

To drain the exciter oil, remove the drain screw (A) on the exciter (A). Then tilt the machine.
Fix the drain screw (B) again and fill up fresh oil (screw (C)). Recommended oil is ISO VG68 or
similar about 350ml is needed for a refill.

Changing the engine oil

Checking the clutch

Check the clutch at the same time as the V-belt. With the belt removed, visually check the
outside for seizure and the "V" groove for wear and damage. Clean the V-groove as required.
If the clutch shoe is worn, the power transmission becomes insufficient.
ZIPPER MASCHINEN GmbH
ZI-RPE60C & ZI-RPE90C34
To drain the exciter oil, remove the drain screw (B) from the exciter
(A) and then tilt the machine. (Note that the oil can drain more easily
when warm.) Then straighten the machine again and top up with fresh
oil. Recommended oil is ISO VG68 or similar about 250ml is needed for
a refill.
Waste oils are toxic and must not be released into the
environment! Contact your local authorities for information on proper
disposal.
1. Remove the oil drain hose (A) from the holder (B).
2. Remove the screw on the oil drain hose. Collect the drained
oil in a collecting container and dispose of it properly!
3. Tighten oil drain plug again after emptying.
4. Top up with fresh oil via the filling opening (K) (see section
www.Zipper-Maschinen.at
N O T I C E
Checking the engine oil level).
Only use high-quality engine oil, e.g. SAE30 or 15W40 or
similar!
MAINTENANCE
34