English Safety Notes Gloves should be worn during installation to prevent crushing and cutting injuries. Installation Instructions • Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured. • The pipes and the fixture must be installed, flushed and tested as per the applicable standards. • The plumbing codes applicable in the respective • Connection with flexible hose countries must be observed. • There must be an access door for maintenance. • When assembling the iBox universal with integrated safety combination (HD) pay attention that the middle of the mixer is min. 280 mm above the upper edge of the bath tub. Center bath tub Technical Data Operating pressure: max. 1 MPa Recommended operating pressure: 0,1 - 0,5 MPa Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI) Hot water temperature: max. 70°C Recommended hot water temp.: 65°C Thermal disinfection: max. 70°C / 4 min The product is exclusively designed for drinking water! Symbol description Do not use silicone containing acetic acid! • When installing a different flush-type fitting than the Dimensions (see page 5) iBox universal, DIN EN 1717 requires the pipe...
Deutsch Sicherheitshinweise Bei der Montage müssen zur Vermeidung von Quetsch- und Schnittverletzungen Handschuhe getragen werden. Montagehinweise • Vor der Montage muss das Produkt auf Transportschäden untersucht werden. Nach dem Einbau werden keine Transport- oder Oberflächenschäden anerkannt. • Die Leitungen und die Armatur müssen nach den • Anschluss mit flexiblem Schlauch gültigen Normen montiert, gespült und geprüft werden. • Die in den Ländern jeweils gültigen Installationsrichtlinien sind einzuhalten. • Für Wartungsarbeiten muss unbedingt eine Revisionsöffnung vorgesehen werden! • Bei der Montage der iBox universal mit integrierter Sicherungskombination (HD) ist darauf zu achten, daß die Mitte der Armatur min. 280 mm über dem Wannenrand liegt. Technische Daten Betriebsdruck: max. 1 MPa Empfohlener Betriebsdruck: 0,1 - 0,5 MPa Prüfdruck: 1,6 MPa (1 MPa = 10 bar = 147 PSI) Heißwassertemperatur: max. 70°C Empfohlene Heißwassertemperatur: 65°C Thermische Desinfektion: max. 70°C / 4 min Das Produkt ist ausschließlich für Trinkwasser konzipiert! Symbolerklärung Kein essigsäurehaltiges Silikon verwenden! Maße (siehe Seite 5) Durchflussdiagramm (siehe Seite 5) • Bei der Montage anderer Unterputzarmaturen als...
Seite 5
Exafill 58129003 r = m i n .10 0 Ø 74 Ø 7 2 G 1 1 / 2 m a x . 8 3 0 with flow limiter mit Durchflussbegrenzer without flow limiter ohne Durchflussbegrenzer...