Glossary - Philips Flat TV 20PFL5122 Bedienungsanleitung

Troubleshooting Tips
Symptom
Cannot access Install
menu
PC modes do not
work
S-Video colour
becomes faint
Black bar on top
and bottom of
screen in PC mode

Glossary

DVI (Digital Visual Interface) : A digital interface
standard created by the Digital Display Working Group
(DDWG) to convert analog signals into digital signals to
accommodate both analog and digital monitors.
VGA (Video Graphics Array) : a common standard
graphics display system for PCs.
RGB signals : These are the three video signals, Red
Green Blue, which make up the picture. Using these
signals improves picture quality.
S-VHS signals : These are 2 separate Y/C video
signals from the S-VHS and Hi-8 recording standards.
The luminance signals Y (black and white) and
chrominance signals C (colour) are recorded
separately on the tape. This provides better picture
quality than with standard video (VHS and 8 mm)
where the Y/C signals are combined to provide only
one video signal.
NICAM sound : Process by which digital sound can
be transmitted.
16:9 : Refers to the ratio between the length and
height of the screen. Wide screen televisions have
a ratio of 16/9, conventional screen TV sets have a
ratio of 4/3.
Possible Causes
• In AV, EXTERNAL or
HD mode
• Wrong connections
• Wrong source selected.
• Wrong display resolution
• Wrong setting of PC
graphic card
• Wrong detection of
signal
• PC refresh rate too high
What you should do
• Press AV key and select TV mode. You can now
access the Install menu by using the Menu key.
• Check whether connections are correct. (see
Connecting your Computer" on page 17).
"
• Check whether the source is correctly selected.
Press button to enter Source list and select
the correct source.
•
Check whether you have configured the computer on
a compatible display resolution (see "Connecting
your Computer" on page 17).
• Check graphic card setting of PC.
• Check whether power cord is properly connected
• Press the P + key on the remote control to do a
channel up and then press up P – key control to do
a channel down.
• Change PC refresh rate to 60 Hz.
HDMI (High-Definition Multimedia Interface) :
Provides an uncompressed, all digital audio/video
interface between the TV and any HDMI-equipped
audio/video component, such as set-top box, DVD
player and A/V receiver. HDMI supports enhanced or
high-definition video plus two-channel digital audio.
System : Television pictures are not broadcast in
the same way in all countries. There are different
standards: BG, DK, I, and LL'. The System setting (p. 6)
is used to select these different standards. This is not
to be confused with PAL or SECAM colour coding.
PAL is used in most countries in Europe, SECAM in
France, Russia and most African countries. The United
States and Japan use a different system called NTSC.
HDCP (High-bandwidth Digital-Content Protection):
HDCP encrypts the transmission of digital content
between the video source or transmitter such as a
computer, DVD player or set-top box and the digital
display or receiver such as a monitor, television or
projector.
21