Add Users (Mode 1 And 2); Remove Users (Mode 1 And 2); Sound On Or Off - Flexlock Visible 2.0 Handbuch

7.4 Add users (Mode 1 and 2)

1. Place the programming card on the lock for about 3 seconds,
then remove it. You will now hear the programming signal.
2. Place the user card on the lock within 7 seconds,
a confirmation signal is heard.
3. Continue adding users by repeating the above
(maximum 200 users).

7.5 Remove users (Mode 1 and 2)

1. Place the programming card on the lock for about 3 seconds,
then remove it. You will now hear the programming signal.
2. Place the user card to be removed on the lock
until an erase signal sounds.
3. To check, wait for 5 seconds, place the user card on the lock.
If everything is correct, an error signal will sound.

7.6 Sound on or off

By default, the confirmation sound
To turn the sound off, do the following:
1. Place the programming card on the lock for about 3 seconds,
then remove it. You will now hear the programming signal.
2. Place the sound on/off card on the lock within 7 seconds.
Programming signal is cut off (only when programming to
sound off. When programming to sound on, a double
confirmation signal is heard
To turn the sound on, repeat the above procedure.
7 SEC
7 SEC
for opening and closing is on.
7 SEC
).
7.4
7.5
7.6
English 9