Programming; Programming From Mode 1 (Default Setting) To Mode 2, 3, 4 Or 5; Reset The Lock To Mode 1 (And Erase All Users In Mode 1 And 2); Programming Ready To Use (For Locks In Mode 1 Or 2) - Flexlock Visible 2.0 Handbuch

7 Programming

When programming, you need a programming card, service card and Mode-card or user card
depending on what function you desire.
!
When changing between modes you always have to change via Mode 1. Reset the lock
to default mode according to 7.2. (E.g. Mode 3 -> Mode 2 needs to be:
Mode 3 -> Mode 1 -> Mode 2.)

7.1 Programming from Mode 1 (default setting) to Mode 2, 3, 4 or 5

1. Place the programming card on the lock for about 3 seconds,
then remove it. You will now hear the programming signal.
2. Place the selected Mode card on the lock within 7 seconds
until you hear a double confirmation signal.
!
In Mode 1 and 2 you also have to add user cards to
the lock. See under 7.4.

7.2 Reset the lock to Mode 1 (and erase all users in Mode 1 and 2)

1. Hold the programming card on the lock for about
10 seconds. A reset signal is heard.
All users have been erased and the lock is now in Mode 1.

7.3 Programming Ready to use (for locks in Mode 1 or 2)

1. Place the programming card on the lock for about 3 seconds,
then remove it. You will now hear the programming signal.
2. Place the Ready to use card on the lock within 7 seconds until
you hear a double confirmation signal.
ready for a new unique user that will be added to the lock.
8 English
7 SEC
7 SEC
7 SEC
The lock is
7.1
7.2
7.3