Specifications; Safety Warnings - Makita DDF485 Betriebsanleitung

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
D rilling c apac ities
F astening c apac ities
No load speed
O v erall length
R ated v oltage
Net w eigh t
Due to our continuing program of research and development, the specifications herein are subject to change
w it h out noti c e.
Specifications may differ from country to country.
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure
Applicable battery cartridge
BL N / BL / BL
Some of the battery cartridges listed above may not be available depending on your region of residence.
Only use the battery cartridges listed above. Use of any other battery cartridges may cause
WARNING:
injury and/or fire.
Intended use
T h e tool is inten d e d f or d rilling an d s c re w d ri v ing in
w oo d , metal an d plasti c .
Noise
The typical A-weighted noise level determined accord-
ing to EN - - :
S oun d pressure le v el ( L
pA
Uncertainty (K) : dB(A)
The noise level under working may exceed
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN
Work mode: drilling into metal
Vibration emission (a ) : . m/s
h ,D
Uncertainty (K) : . m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
anot h er.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
e x posure.
S teel
W ood
W ood sc rew
Mac h ine sc rew
H igh ( 2)
L ow ( 1 )
B / BL / BL
) : dB(A)
dB (A).
- - :
2
or less
2
/ , are shown in the table.
B / BL / BL B / BL
WARNING:
use o f t h e po w er tool c an d i f f er f rom t h e d e c lare d
emission value depending on the ways in which the
tool is use d .
WARNING:
to protect the operator that are based on an estima-
tion o f e x posure in t h e a c tual c on d itions o f use ( taking
account of all parts of the operating cycle such as
t h e times w h en t h e tool is s w it c h e d o f f an d w h en it is
running i d le in a d d ition to t h e trigger time ) .
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to t h is instru c tion manual.

SAFETY WARNINGS

General power tool safety warnings
WARNING:
tions, illustrations and specifications provided
with this power tool. F ailure to f ollo w all instru c tions
listed below may result in electric shock, fire and/or
serious injury.
4 ENGLISH
DDF485
1 3 mm
38 mm
6 mm x 75 mm
M6
-1
0 - 1 ,9 00 min
-1
0 - 5 00 min
1 6 9 mm
D .C . 1 8 V
1 .4 - 1 .7 kg
/ BL B / BL B
The vibration emission during actual
Be sure to identify safety measures
Read all safety warnings, instruc-