Troubleshooting; Disposal Information - WOLFF JUNIO-STRIPPER Originalbetriebsanleitung

6.2 Spare parts
Spare parts can be found on the internet at:
http://webkatalog.wolff -tools.com

7.0 Troubleshooting

Fault Possible cause Remedy
The machine Power supply
does not start interrupted
Defective cable
Defective plug
Higher exer- Knife blunt
tion of force
required while
working
high vibration Wear parts of
the machine are
knocked out
The machine Coal is worn out
turns off

8.0 Disposal information

Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable
must be collected separately and disposed of in an envi-
ronmentally correct manner.
Subject to change without notice
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
9.0 Notes on various fl oor coverings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The JUNIO-STRIPPER is primarily used to remo-
ve linoleum, PVC, rubber, cork, design, and CV
coverings as well as needle-punched fl oor cover-
ing and carpeted fl ooring.
► Needle-punched fl oor covering, carpet, PVC.....
Contact Electrici-
an.For repair and
The coverings to be removed should be pre-cut in
/or replace parts
blade-widths (Pic. B) and then removed with the
stripper in one step. In many cases, the glue can
also be removed at the same time.
Replace knife
► Coverings without a foam backing:
Prior to performing the stripping work, pre-cut the
strips in blade-widths (Pic. B). Regularly check
Send in the ma-
whether the blade is still straight and sharp.
chine for repair
► Coverings with a foam backing:
Replace the coal
in the service
Only use sharp blades! Remove the large Sections of
workshop
the wearing surface. Use a carpet pulling claw for this.
Then remove the foam residue with the stripper. If
there is some foam in the recess, approach from the
side.
► Coverings with a fl eece backing:
Do not remove the wearing surface beforehand. Cut
the covering into strips and strip them together with the
fl eece backing.
In general, no statements can be made on which
blades can be used for which blades, because the
variety of coverings and surfaces are too diverse.
These recommendations are to provide assistance!
► We recommend using fl at blades of varying lengths
and widths for fl exible, elastic fl oor coverings. The
harder the covering, the thicker the blade should be.
► The blade is generally inserted with the blade edge
up, unless it works itself too deep in the surface. In
www.wolff -tools.de
Warning
Important blade recommendation:
EN
17