Status Messages/Error Messages - Zoef Robot BERTA Gebrauchsanweisung

Status messages/error messages

E 1
Emergency off actuated
Re-start the robot
E2
Lifting sensor triggered
Rear wheel blocked or lifted? Restore
the rear wheel then re-start the robot.
E3
Robot outside of the boundary line
primeter.
Place robot inside, restart
E4
Boundary line cut
Red indicator LED flashes? Repair
boundary line, restart robot
E5
Collision sensor triggered
nder
Obstacles? Re-start the robot
s
t
E6
Overcurrent on the left drive-motor.
Grass too high? ( > 4cm)? Left wheel
blocked? Re-start the robot
E7
Overcurrent on the right drive-motor.
Grass too high? ( > 4cm)? Right wheel
blocked? Re-start the robot
E8
Overcurrent at the cutting motor
Grass too high? ( > 4cm)? Cutting sleeve
blocked? Re-start the robot
E9
Error charging status
Malfunction of the battery. Re-start
the robot multiple times, if the issues persisits,
contact service.
E 10
Over-/undercurrent of the robot.
Malfunction on the PCB bodard. Restart
the robot multiple times, if the issues persists,
contact service.
E 11
Tilting sensor tripped
Inclination in excess of 20 degrees? Re-
start the robot
E 12
Wheel slipping
Grass too high or too wet? Re-start the
robot.
E 13
Overheating on battery
Wait for the battery to cool down.
Re-start the robot.
F 1
Robot does not start, signal
present
Robot is started outside of the boundary line or too far
from it? Restart the robot.
F2
Robot does not start, no signal
(charging station)
Boundary line/mains adapter correctly
connected?
F3
Robot does not start
The power of robot mower is turned off previously?
-
Bring it onto the charging station and restart it.
F4
Battery voltage too low
Completely charge the robot
Re-start the robot
1.
Place the robot on the boundary line
2. Enter the safety code
3. Push the start button
If the robot is turned off previously, it can only be
started on the charging station.
User Manual
EN
| 21 |