Initial Setup - Zoef Robot BERTA Gebrauchsanweisung

Initial setup

Please read safety instructions before setup. Check the appliance for completeness.
1
2
3
4
< 0.7 m
150x
5
| 20 |
Place the charging station
Comply with distances and
alignment!
Install the charging station
level and near a power
source!
Place the boundary line
under the charging station
in a cable groove
Consider at least 50 cm
reserve at the ends!
Fasten the charging station
6x
Place the boundary line
taut with the nails
Place the boundary line
< 2 - 3 cm in the ground!
Recommendation: Place the
boundary line taut on the
lawn. The boundary line will
grow into the lawn.
Remove the cover
6
2x
7
8
9
User Manual
Place the wire in the
clamp and close it firmly
Strip the boundary line
if necessary!
Connect the terminals
Connect the boundary line under
the charging station to the plus
connection! Connect a different
cable to the minus connection!
Connect the mains unit
Correct installation
Defective installation:
(kink/interruption/loose
(red)
contact)
Apply the cover
Completely charge the robot
before initial commission-
ing!