Reverse Playback; Time; Single Playback; Repeat Playback - Renkforce CMP-960USB Bedienungsanleitung

REVERSE Playback

When the REVERSE function is activated, the track is played backwards.
• Push the button REVERSE (18) to activate or deactivate this function. The button lights up when the REVERSE
function is activated.
The REVERSE function is deactivated when the track start is reached. The track is now played normally
again.

TIME

Use the TIME (10) button to switch between the different times displayed (elapsed track time > remaining track time
> total remaining time) on the LC display (8).
• Push the TIME button (10) until the desired time display appears in the LC display.
The total remaining time is only displayed for audio CDs. With MP3 music files, the total playing time is not
displayed.

SINGLE Playback

• For single track playback, the device enters pause mode after each track played. The CUE mark is automatically
set to the beginning of the new track.
• Use the button SINGLE (11) to select single track playback. In the playback mode SINGLE, the display shows
"SINGLE"

REPEAT Playback

REPEAT 1: The current track is repeated continually (single track repeat).
REPEAT ALL: This setting continually repeats the selected playback source.
• Select the single track repeat function or continuous repeat function with the REPEAT button (12).
The corresponding setting appears in the LC display (8).

SCRATCH Function

When the SCRATCH (vinyl) function is activated, you can scratch the track selected with the JOG wheel (4) on a
record player.
• Select the function SCRATCH with the button JOG MODE (22). The button JOG MODE (22) flashes with the
function active.
• Now turn the JOG wheel (4) to scratch.
45