Title Programming; Switching Off - Renkforce CMP-960USB Bedienungsanleitung

Title Programming

• To start programming, the CD player must be switched to pause mode. A maximum of 20 tracks can be programmed.
• Push the PGM button (13). "P-01" and "PROGRAM" will be displayed.
• Use the buttons SKIP
• Push the PGM button (13) to save the track. "P-02" and "0 Track" will be displayed.
• Use the buttons SKIP
• Push the PGM button (13) to save the track. "P-03" and "0 Track" will be displayed.
• Repeat the individual steps of track selection and storage until all desired tracks were stored.
The button PGM (13) can be used to check the programming. Push the button repeatedly to display all
saved tracks. Select the last memory slop with the PGM button (13) until the display "0 Track" appears in
the display. Now you can continue programming if you wish.
You may also change a saved title of a programming. Select the programme slot to be changed in pro-
gramming mode with the button PGM (13). Use the buttons SKIP
keyboard (20) to select the new track. Save the track by pushing the button PGM (13).
• Start programming playback with the PLAY/PAUSE button
Push the button PGM (13) in pause mode to open the programming again. Select and save other titles to
expand or change programming. Start programming playback with the PLAY/PAUSE button (3).
Programming playback can be exited using the 10-digit keyboard (20). Select a track with the 10-digit
keyboard (20). The selected title is played back. At the end of the title, the CD player returns to play- back
of the title programming.
• Push and hold the button PGM (13) to delete the programming. The display "PROGRAM" stops appearing in the
display.

Switching off

• Interrupt playback by pushing the PLAY/PAUSE button
• Switch off the amplifier and any connected mixer.
• Only then switch off the CD player with the main switch (1).
46
(26 / 25) and the 10-digits keyboard (20) to select the corresponding track.
(26 / 25) and the 10-digit keyboard (20) to select the next track.
(3). The display "PROGRAM" flashes in the display.
(3).
(26 / 25) and the 10-digit