Peaq PDR220 Bedienungsanleitung Seite 44

ENGLISH
PRIVATE NETWORK CONNECTION
Select WPS connection type
If a network is protected by a WEP or WPA
encryption, the query for constructing a
connection over WPS (Wi-Fi Protected
Setup) appears. If the router of your wire-
less network has a WPS function, select
whether the WPS connection should be
established by entering a PIN code over
the WPS key on the router.
WPS connection using PIN entry
A WPS-PIN appears in the Internet radio
display. Enter this PIN and confirm the In-
ternet radio with OK. The WPS connection
will then be established.
Connection using WPS key
Press the WPS key on the router and then
confirm the display on Internet radio with
SELECT. The WPS connection is then es-
tablished.
CONNECTION USING THE DIRECT EN-
TRY OF THE NETWORK KEY
If you do not want to establish any con-
nection using the WPS, select the entry,
No WPS and then enter the network key
in the following dialogue. Confirm the entry
with SELECT.
44
IM_PDR220_160303_A_V04_HR.indb 44
COMPLETING THE WLAN CONNECTION
1. The connection begins. The device
should now establish a connection
with the WLAN. Once the connection
has been established, the notification
<Setup-Assistant is finished> ap-
pears. Confirm the display with SE-
LECT.
2. If the WLAN cannot be accessed (e.g.
locked for new WLAN devices) the fail-
ure notification "Connection not suc-
cessful" appears.
3. In this case, check the setting of your
WLAN-router.
Note
The entered password (WEP/WPA key) will
be saved and will not need to be entered
again.
3/3/16 11:19 AM