General Operation; Listening To The Radio - AEG MC 4432 CD Bedienungsanleitung

WARNING:
• Avoid contact with metallic objects. (Rings, nails,
screws et cetera.) There is a danger of short-circui-
ting!
• As a result of a short-circuit batteries may heat up
considerably or even catch fire. This may result in
burns.
• For your own safety the battery poles should be
covered with adhesive strips during transport.
• If a battery leaks do not rub the liquid into your
eyes or mucous membranes. If hands come into
contact with the liquid they should be washed
thoroughly and eyes rinsed out with clear water;
if symptoms persist please consult a doctor.
CD deck transport protection
• Please open the CD compartment (1) by pressing the
 (open) button (4).
• Remove the transport protection from the CD player
if present before use.

General Operation


NOTE:
Some keys are to be found both on the device itself
and on the remote control. Keys with the same desi-
gnation have the same function.
Volume
You can set the desired volume using the VOLUME+/-
buttons (6).
BASS BOOST OFF/ON (23)
To increase or decrease the bass output.
ON = on, OFF = off.
Switch-off
The machine is switched off when the function selector
switch (17) is turned to the TAPE/OFF position. Unplug
the device.
AUX IN socket
To connect analogue replay devices. Via this socket you
can also hear the sound of other playback devices such
as MP3 players, CD players etc. through the loudspeakers.
1. Please connect the external device with a 3.5 mm
stereo jack plug to the AUX IN socket (7).
2. Turn the function selection switch (17) to AUX IN.
3. For the remaining procedure please see the operating
instructions of the external sound source.
4. Through the loudspeakers you now hear the sound
from the external device; with the VOLUME+/- but-
tons (6) you can change the volume. The CD buttons
do not have any function.
05-MC 4432 CD.indd 43

NOTE:
Adjust the volume of the external device to a comfor-
table level.
USB Connexion (20)
This device has been developed in accordance with
the latest technical developments in the USB field.
Unfortunately the large number of different types of
USB storage media on offer today makes it impossible to
guarantee full compatibility with all USB storage media.
For this reason there may be problems in rare cases
with playing back from USB storage media. This is not a
malfunction of the device.
1. Turn the function selector switch (17) to the CD/
MP3/USB.
2. Insert a USB storage medium directly into the cor-
responding connection.
3. Press the CD/MP3/USB button (22) in order to select
USB mode. USB appears in the display.
4. After a few seconds the total number of folders ap-
pears. Then the total number of tracks is displayed.
5. Press the II PLAY/PAUSE button (8/6) in order to
start playback. The display then alternates between
the current song or folder, the letters  MP3 and
USB.
For operating instructions please see the section "Playing
CDs/MP3s".

NOTE:
If there is no CD in the CD compartment at the same
time, the USB connection is automatically selected.
CAUTION:
Before you remove the USB storage medium turn the
function selector switch (17) to the RADIO position.

Listening to the Radio

1. Turn the function selector switch (17) to the RADIO
position.
2. Use the band selector switch (10) to select the desired
frequency band.
VHF (Stereo) = FM ST., VHF = FM,
Medium wave = AM (Mono)
3. Tune in the desired station with the station adjust-
ment knob TUNING (3).
4. The FM.ST control lamp
lights up when you have selected FM stereo and the
station is being received in stereo quality. If reception
is too weak and there is noise on the station being
received, this lamp will flicker.
5. Try to improve reception by turning and bending or
twisting and altering the length of the antenna (27).
Where reception is bad we recommend switching
to FM.
English
43
(in the display) only
12.03.2010 10:21:58 Uhr