Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - GM-Racing Radicator 3.0 Buggy Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

TROUBLESHOOTING

Problem
Motor does not
run
Motor
rotates
reverse
No motor perfor-
mance
The vehicle is
diffi cult to steer
Vehicle without
function
Vehicle is very
loud
LIABILITY FOR PRINTING ERRORS EXCLUDED! WE RESERVE THE RIGHT TO INTRODUCE MODIFICATIONS!
The newest version of this manual can be found in the Internet under www.graupner.de
17
Possible errors
Broken motor wiring
Battery empty
Remote control does not work correctly,
incorrectly adjusted throttle
Motor not working
Throttle trim not properly adjusted
Servoreverse switch throttle in wrong po-
sition
Battery almost empty
Throttle trim not properly adjusted
Drivetrain runs heavily
Drivetrain works loud
Motors gets very hot
Transmitter batteries empty
Steering trim not properly adjusted
Interferences
Throttle trim not properly adjusted
Transmitter LED's not illuminated
Transmitter - receiver not bound correctly Re-bind transmitter and receiver (see the relevant chap-
Throttle trim not properly adjusted
Receiver antenna without contact
Battery contacts dirty or bent
Transmitter LED's not illuminated
Gear mesh between pinion and gear not
adjusted correctly
Gears or bushings worn out
Bushings runs heavily
GM-Racing Radicator 3.0 Buggy - Truggy - Monster Truck
To do
Resolder wiring
Change or charge battery
Check remote control, adjust throttle trim
Change motor
Set throttle trim to neutral
Servoreverse switch in correct position (left)
Change or charge battery
Set throttle trim to neutral
Check, clean drivetrain
Check gear mesh
Let motor cool down; check drivetrain, gear mesh, check
for binding parts
Change or charge battery
Trim steering servo with the adjustment knob on the left
side of the steering wheel
Make a short break an then try again
Set throttle trim to neutral
Check if transmitter is powered on
ter in this manual)
Set throttle trim to neutral
Check receiver antenna
Clean the contacts, re-adjust with a screwdriver
Change or charge battery
Check and re-adjust gear mesh
Check, change if necessary
Check, lube if necessary

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis