Jaga BRIZA 22 HYBRID Anleitung Seite 45

B.1. FACTORY SETTINGS
The device is controlled via auto-change-over. The unit starts as soon as the set water
temperature has been reached. The user can temporarily select another mode manually.
Auto-change-over. The unit starts at the last selected speed(1, 2 or 3), as soon as the water
temperature > 28 ̊ C .
Only with configuration code FCC.BRC62 / FCC.BRC64!
Auto-change-over. The unit starts at the last selected speed(1, 2 or 3), as soon as the water tempera-
ture < 18 ̊ C .
The unit is in standby. The unit automatically starts a new cycle as soon as the set temperature
has been reached.
Permanently off All functions are disabled until the user switches on the unit via the control panel.
B.2. CONTROL
Press the button until the desired mode is
reached (± 3 sec.)
When auto-change-over mode the controller
itself will select the desired operation mode.
The user can always choose manually a
different mode of operation.
Windowcontact
ON
Manually raising / lowering the fan speed:
1
MODE 1
Fanspeed: 1
Red LEDs
MODE 1
(Tw < 28 ̊ C ).
E 01 OPTIE 02
Blue LEDs
7 stand C
(Tw > 18 ̊ C ).
MODE 1
Window contact
ON
5 6 7 8 1 2 3 4 5 6
MODE 1
BRIZA 22 - JFCC | MANUAL | V_05
Activator speed is set according to the unit's length.
ON
1
2 3
are flashing in the set mode: the water temperature of the supplied water is too low
2 3
OPTIE 03
are flashing in the set mode: the water temperature of the supplied water is too high
stand E
2 3
The window contact is not activated by default and has to be activated /deactiva-
ON
ted manually.
7 8 1 2 3 4 5 6 7 8
Switch on: turn on the DIP switch 1
2 3
MODE 1 2 3
MODE 1 2 3
Fanspeed: 2
MODE 1 2 3
MODE 1 2 3
Windowcontact
ON ON
1 1
MODE MODE MODE 1 1 1 2 2 2 3 3 3
MODE MODE MODE 1 1 1 2 2 2 3 3 3
3"
3"
MODE 1 2
3"
MODE 1 2
Only with configuration code
FCC.BRC62 / FCC.BRC64!
MODE 1 2
Fanspeed: 3
MODE 1 2
MODE MODE MODE 1 1 1 2 2 2
MODE MODE MODE 1 1 1 2 2 2
EN
3
3
3
3
3 3 3
3 3 3
45