English - Peavey Headliner Bedienungsanleitung

Tour Series Headliner
™
Bass Amplifier
Welcome to Peavey bass amplification!
®
Peavey bass guitar amplifiers are legendary for their state of the art features, class-leading power, superb tone, and
unmatched reliability. The Peavey Headliner is a 600-watt bass amplifier head that puts an incredible range of features at
players' fingertips. The amp features a seven-band graphic EQ spaced at optimized frequencies, with each slider providing 15
dB of cut and boost, to provide comprehensive tone shaping at precise frequency bands. Players can use the graphic EQ in
conjunction with the low and high shelving-type tone controls, or bypass the graphic EQ entirely. A built-in optical Compressor
with level control and bypass allows players to add the right amount of compression to the mix, while the Crunch feature
adds a vintage tube effect that distorts only the high frequencies, preserving the all-important fat low end. The amp also
features Bright and Contour switches, effects loop, master volume and headphone out. The Compressor and Crunch features
are footswitch selectable. The Headliner features a built-in XLR direct interface that players can use to route the signal to
the house sound system or recording device, and an active/passive pickup switch that compensates for hot inputs. Peavey's
exclusive DDT speaker protection circuitry senses the onset of clipping and responds with slight compression that allows the
™
amp to retain the tone, headroom and dynamics.
Please read this guide carefully to ensure your personal safety as well as the safety of your amplifier.
FEATURES:
• 7-band graphic equalizer with push-button bypass
• Class D Power Section
• Patented DDT (Distortion Detection Technique) technology
™
• Built-in Crunch effect
• Studio quality balanced DI output
• Built-in Optical compressor
• Buffered Effects Loop
• Twist-lock combination Powered Speaker Output
• Active/Passive Instrument Switch
• Pre and Post Gain controls
• Low & High Shelving EQ
• Contour Control
VENTILATION: For proper ventilation, allow 12" clearance from the nearest combustible surface.
All vents should have a minimum of 2" of free air space so air can flow thru the unit freely for proper cooling.

ENGLISH

™
15