Concept GE 2005 Bedienungsanleitung Seite 35

INSTALLING YOUR GRILL MAKER
The grill maker is for indoor use only. Place the unit away from water and do not use it
near a swimming pool. Do not expose the unit to rain. The unit must be plugged into an electrical outlet.
Place the grill maker on a flat, stable and heat resistant surface.
Prior to the first use
1. Clean the plates with a wet soft cloth and then dry the unit.
2. Connect the grill maker to a grounded electrical outlet.
Set the thermostat knob to the r ight side position (Dark) . Do not place food on the plate.
3.
The device can emit smoke during its first use.
4. After about 4-5 minutes, turn the appliance off and let it cool down.
5. Insert the grease collector tray at the back of the device. Now you can use the unit.
Assembly & operation
The Grill GE 2005 is a really versatile piece of kitchen equipment. There are many different ways to use the g rill.
The ribbed grill plates are ideal for steaks, kebabs and paninis.
1. Connect device with electric network.
Set required temperature ( Light = light browning, Dark = dark browning) .
2.
When the green light turns off , the grill is ready for use (2-3 min) .
3.
4. When the temperature drops below the set value the
green light t urns on . When temperature corresponds with
set temp. the light turns off again. The process is repeated
several times during preparation.
Fully open position
For fully open position, press the lever and push the handle
back (see part C in figure 1).
Half open position
The grill can be used in the half open position. To adjust
the appliance to this position, simply lift the handle until it
comes into the fully upright position. The unit will stay in this
position until you close the cover or continue to open it to
the fully open position.
GE 2005
Fig. 1
Fig. 2
EN
35