Optoma DLP PT100 Bedienungsanleitung Seite 12

USING YOUR PROJECTOR
Input Source Menu
Use and Buttons to select Composite Video or PC (VGA) Input. (Factory
default is composite video)
Composite Video On Screen Display(OSD)
After composite video source is connected, "Composite Video OSD" may continue to display for
few seconds, until source detection is finished, and composite video image appears on the screen.
If composite video is not detected "Composite Video Source Not Found OSD" will appear
If this happens, please check that composite video source is plugged in and turned ON.
PC VGA On Screen Display(OSD)
After PC VGA source is connected, "PC VGA OSD" may continue to display for few seconds, until
source detection is finished, and PC VGA image is appears on the screen.
If PC VGA is not detected "PC VGA Source Not Found OSD" will appear.
If this happens please check PC VGA Source is plugged in and that resolution is set to 640 x 480
@ 60 Hz or 800 x 600 @ 60 Hz or 1024 x 768 @ 60 Hz.
If PC VGA source is Apple PC then resolution should be set to 1024 x 768 @ 60 Hz.
TM
GB-10