Sthor 79275 Originalanleitung Seite 13

PRODUCT CHARACTERISTICS
Wall chaser is a kind of electric cutter, which, using a set of diamond discs, allows to perform two incisions on substrate of ceramic
materials (eg. concrete, brick, gypsum) in a straight line. The substrate, which is remaining after cutting between the slots, must
be removed with a chisel (not included in the tool equipment) or a the device for breaking out, to forming a chase, which can be
used to lay: water and gas pipes, electrical wires etc. Wall chaser is a power-driven device powered by single-phase alternating
current. The product is designed for DIY and can not work in commercial applications. Correct, reliable, and safe operation of the
device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damage caused by failure to comply with safety regulations and instructions of this manual, the supplier is not respon-
sible.
EQUIPMENT
The wall chaser is supplied in a complete state and requires no assembly but it may require to set the discs space before starting
its operation. Along with the wall chaser there are delivered diamond cutting discs, the key, which is necessary to exchange the
discs, the device for breaking out chases and the system connection for dust extraction.
TECHNICAL DATA
Parameter
Catalog number
Mains voltage
Mains frequency
Rated power
Insulation class
Rated revs
Cutting depth
Cutting width
Cutting disc
Outer diameter
Internal diameter
Max. thickness
Thread size of the spindle
Weight
Noise level
- accustic pressure LpA ± KpA
- accustic power L ± K
wA wA
Vibration level (main handle. / additional handle) a
Degree of protection
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock.
O R I G I N A L
GB
Unit
[V]
[Hz]
[W]
[min -1 ]
[mm]
[mm]
[mm]
[mm]
[mm]
[kg]
[dB(A)]
[dB(A)]
± K [m/s ]
2
h
I N S T R U C T I O N S
Value
79275
230 AC
50
1700
II
4 000
0 - 28
14 / 19 / 29
125
22.2
1.9
M12
5.1
101.88 ± 3.0
112.88 ± 3.0
9,430 ± 1,5 / 9,564 ± 1,5
IPX0
13