CAME BPT TH/500 Montage- Und Betriebsanleitung Seite 39

Configuration of general parameters of the device
When the device is in Manual mode , holding down the
uration screens.
Note. After accessing the configuration screens, pressing the
to be configured in sequence, the
screen in figure A.
button lets you exit the configuration window and go back to the
A
B
C
D
button A gives access to the device's config-
button lets you display the parameters
Enabling the screen lock
The factory settings do not provide any
protection from changes for the device B.
To leave this setting unchanged and move on
to the next parameter, press the
If you want to protect the device from un-
wanted changes to programming, use the
arrows to enable the screen lock C.
Press the button to access the window
that lets you set the code (password) that
must be entered to unlock the device.
The first number flashes D; use the
arrows to enter the first digit of the
code, and the arrow to move on to the
next digit; pressing button
means the code entered is considered valid
and you move on to the next parameter to
be configured.
button.
at any time