CAME BPT TH/500 Montage- Und Betriebsanleitung Seite 32

Pre-set weekly temperature programming (automatic mode)
To allow immediate use of the device a standard set-up has been provided for it to operate in heating mode
and another for cooling mode, where the fixed temperature levels are:
Heating
Anti-frost (default 3 °C)
T1 16 °C
T2 18 °C
T3 20 °C
If the temperature trends programmed correspond to your requirements, the device is ready to work correctly
straightaway.
Changing the system's operating mode
Touch the area shown in figure A and
continue touching until a beep indicates the
mode is changed between:
System in Heating mode
System in Cooling mode
System off
A
System in Frost-protection mode
When the system is off ( ), the image in
figure B is displayed on the screen for a few
seconds, to indicate that the programmable
thermostat is off; Then the temperature
detected will reappear.
When the system is put into frost-protection
B
mode C ( ) the arrows let you set the min-
imum ambient temperature tolerated; Then
the temperature detected with reappear.
Note.
Programmable frost-protection temperature:
Minimum 3.0°C – Maximum 16.0°C.
C
Cooling
Off
24 °C
26 °C
28 °C