Steelcase Migration Desk & Bench Kurzanleitung Seite 5

In the case of previously saved desk positions, the desktop movement is stopped
briefly. Then the movement continues.
(+ optional Memory control panel)
5. Settings
5.1 Saving desktop positions (Memory control panel)
 Press the respective "Up / Down" button to reach the desired desktop height.
 Press the Memory button; S is indicated on display.
 Press the desired Memory position button; e.g. 2
The set desktop position is being stored. There will be an audible double click. The saved desktop
position is indicated after about 2 seconds.
5.2 Calling up a saved position (Memory control panel)
 Press and hold the desired memory position button, e.g. 2.
The desktop moves until the stored desktop position is reached.
If the position button is released before the saved desktop position is reached, the lift movement
will be stopped and the saved desktop position will not be reached.
 Release the Memory position button as soon as the saved desktop position has been reached.
The current desktop position is indicated on the display, e.g. 73 cm.
If the desktop is not moved within 5 minutes after the reminder, the reminder
function will turn off automatically.
5.3 Manual desk reset
 Press and hold the "Down" button until the lower end position (programmed desktop position) is
reached.
 Release the "Down" button
 Again, press and hold the "Down" button for approx. 5 seconds.
The desktop moves to the lower end position.
 Release the "Down" button. The system is now ready for operation.
142821
S 2 is then indicated on the display.
;
Migration
EN
Rev. A