Preface; Safety; Duty Of Care Of Operator - Nederman 889 Ex-Serie Bedienungsanleitung

2

Preface

Read all product documentation and product identification plate carefully before installation,
use, and service of this product. Replace documentation immediately if lost. Nederman
reserves the right, without previous notice, to modify and improve its products including
documentation.
This product is designed to meet the requirements of relevant EC directives. To maintain this
status, all installation, maintenance and repair is to be done by qualified personnel using only
Nederman original spare parts and accessories. Contact the nearest authorized distributor or
Nederman for advice on technical service and obtaining spare parts. If there are any damaged
or missing parts when the product is delivered, notify the carrier and the local Nederman
representative immediately.
3

Safety

This document contains important information that is presented as either a warning, caution
or note. See the following examples:
WARNING! Risk of personal injury.
Warnings indicate a potential hazard to the health and safety of personnel, and how that
hazard may be avoided.
CAUTION! Risk of equipment damage.
Cautions indicate a potential hazard to the product but not to personnel, and how that hazard
may be avoided.
NOTE! Notes contain other information that is important for personnel.
4

Duty of care of operator

This state-of-the-art hose reel provides maximum safety. No alterations must be made to
the device. During operation, this level of safety can only be achieved in practice if all the
necessary measures are taken. The operator has a duty of care to plan such measures and to
verify that they have been taken.
WARNING! Risk of personal injury.
In particular, the operator must ensure that:
• the product must only be used for approved media (air and water).
• the ATEX classification is adequate for the intended application and that all attached
components are also suitable for the ATEX classification.
• the device will only be used mechanically and electrically in accordance with the
instructions.
• all necessary personal protective equipment is available for operating, maintenance and
repair staff.
• the operating staff are adequately informed and trained in handling and repair, especially
with regard to conduct in ATEX zones.
•
dust deposits and caked layers are removed regularly or according to operational
requirements (see Commissioning, Service and Maintenance), taking care not to stir up the
dust.
Series 889 Ex EN
9