auna Birmingham Bedienungsanleitung Seite 29

installation instructions
• Unpack all parts of the unit and remove all packing material.
• Do not plug the appliance into a wall outlet until you are sure that the
voltage on the appliance's nameplate matches the voltage and that all
connections have been made.
• Do not block the air vents or allow several centimeters of space around
the product to allow adequate ventilation.
• Plug the power plug (32) into the wall outlet.
• When you plug in the unit for the first time, „auna" will be displayed on
the screen.
• Approximately 30 seconds later, when the device is used for the first
time, it automatically starts the Setup Wizard and the screen displays
„Start now" with „YES" (yes) as the default response. Press OK (7) to
start the Setup Wizard.
• The device then opens the automatic update mode. Select an update
source with the
/
button (7). The time zone selection then opens.
• Select the desired time zone with the
selection by pressing the OK button (7). The setting for summer and
winter time opens.
• Use the buttons to select summer time and press the OK button
/
(7) to confirm. The network settings now open and „YES" is factory
set. Press the OK key (7) to confirm. The device now opens the region
setting. The factory setting is „Europe".
• Press the OK key (7) to confirm the region. The device then searches for
your router and displays the networks found on the LC screen (2).
• Select the desired router with the
selection by pressing the OK button (7).
• Select „WPS" by pressing the
by pressing the OK button (7).
• Enter the password by pressing the
• Once you have entered the password, select „OK" and press the OK
button (7) to confirm. The device will now connect to the Internet and
once the connection is successful, the Setup wizard completed screen
will appear. Press OK again to continue.
buttons and confirm your selection with the OK
buttons and confirm your
/
buttons and confirm your
/
buttons and confirm your selection
/
buttons.
/
EN
29