Projector Aligmnment Instructions - Chief Manufacturing C3504 Anweisunghandbuch

Instruction Manual
PROJECTOR ALIGNMENT
INSTRUCTIONS
The Universal Ceiling Projector Mount can be adjusted for ver-
tical elevation (pitch), horizontal tilt (roll), and rotation (yaw).
Once the desired position is located and all the screws of the
Universal Ceiling Projector Mount are tightened, the projector
may be removed from its location and replaced using the four
thumb nuts without loosing the registration of the projector.
Align the projector as follows:
Pitch
Adjust pitch using the pitch adjustment screw located on each
end of the Universal Ceiling Projector Mount. Adjust pitch as
follows:
1. Loosen the pitch adjustment screw on each side of the
Universal Ceiling Projector Mount (see Figure 9).
2. Adjust projector angle to desired pitch.
3. Tighten the two pitch adjustment screws.
Roll
Adjust roll using two 1roll adjustment screws on the face and
back of the Universal Ceiling Projector Mount. Adjust roll as
follows:
1. Loosen the roll adjustment screw on the face and back
opposite the pitch clamp (see Figure 9).
2. Adjust projector to desired roll position.
3. Tighten the roll adjustment screw.
Yaw
Adjust yaw by threading or unthreading the Universal Ceiling
Projector Mount on the 1" pipe. Adjust yaw as follows:
1. Loosen the set screw (see Figure 9).
WARNING: Do not turn the Universal Ceiling Projector
Mount to the end of the pipe threads. The
Universal Ceiling Projector Mount, Projec-
tor Interface Plate, and projector will fall
from the pipe if the Universal Ceiling Pro-
jector Mount is unthreaded too far.
2. Adjust projector by turning the Universal Ceiling Projec-
tor Mount on the 1" pipe to the desired yaw position.
NOTE: Overtightening the set screw may damage threads
and make adjusting yaw difficult. Make sure yaw adjust-
ment is set before tightening set screw.
3. Tighten the set screw.
Roll Adjustment Screw
(+/- 4 )
Yaw Adjustment Screw
(+/- 180 )
Pitch Adjustment Screw
(+/- 25 )
Figure 9. Pitch, Roll, and Yaw Adjustment
MSP-DCCC3504
9