Safety Instructions For Operation - Husqvarna LC 141iV Bedienungsanweisung

Always walk when you operate
the product.
Stop the motor before you
•
change the cutting height.
Never make adjustments with
the motor started.
Never let the product stay out
•
of view with the motor started.
Stop the motor and make sure
that the cutting equipment
does not rotate.

Safety instructions for operation

Personal protective equipment
WARNING: Read the warning instructions
that follow before you use the product.
Personal protective equipment
•
cannot fully prevent injury but
it decreases the degree of
injury if an accident does
occur. Let your dealer help
you select the right equipment.
Use heavy-duty slip-resistant
•
boots or shoes. Do not use
open shoes or go with bare
feet.
Use heavy, long pants.
•
Use protective gloves when
•
necessary, for example when
you attach, examine or clean
the cutting equipment.
Safety devices on the product
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
14
• Do a check of the safety devices regularly. If the
safety devices are defective, speak to your
Husqvarna service agent.
To do a check of the cutting cover
The cutting cover decreases vibrations in the product
and decreases the risk of injury from the blade.
• Examine the cutting cover to make sure that there
are no damages such as cracks.
Motor brake handle
The motor brake handle stops the motor. When the
motor brake handle is released, the motor stops.
To do a check of the motor brake, start the motor and
then release the motor brake handle. If the motor does
not stop in 3 seconds, let an approved Husqvarna
service agent adjust the motor brake.
(Fig. 25)
Safety key (models LC 141iV and LC 141i)
The safety key is below the battery lid. The safety key
connects the battery that supplies the motor with power.
• Start and stop the motor to do a check of the safety
key.
• If the safety key functions correctly, the motor only
starts when the key is in position 1.
(Fig. 26)
To examine the start inhibitor
Do a check of the start inhibitor to make sure that it
prevents operation of the motor.
1. Push the motor brake handle in the direction of the
handlebar. The start inhibitor stops the movement.
2. Push the start inhibitor out. (Fig. 27)
3. Release the start inhibitor and make sure that it goes
back to its initial position.
To use the power cord holder (model LC 141C)
The power cord holder decreases the strain on the
power socket and the power cord. The power cord
holder also decreases the risk that you fall.
1. Bend the power cord to a small loop.
2. Put the loop in to the hole in the power cord holder.
3. Put the loop around the hook.
4. Pull the power cord to tighten the loop around the
hook. (Fig. 28)
Battery safety
WARNING: Read the warning instructions
that follow before you use the product.
919 - 001 - 19.10.2018