Vitek VT-1465 Betriebsanweisung Seite 4

ENGLISH
BLENDER SET
Description
1. Blender
(A) Motor unit
(B) Power switch
(L) Speed control
(C) Blade attachment
(D) Measuring cap
(K) Device for mounting
2. Whisk accessories
(E) Reduction unit
(F) Whisk
3. Mini-chopper attachment
(G) Reduction unit
(H) Chopper blade
(I) Chopper bowl
(J) Non-slip base
(О) Bowl for ice crushing
(Р) Ice chopper blade
Before operating the unit read all instruc-
tions carefully.
• Attention: blades are very sharp!
• Always unplug the unit before assem-
bling, dissembling, cleaning and keep-
ing.
• Before using the unit for the first time,
make sure that your home electricity sup-
ply corresponds to the voltage specified
on the housing.
• Keep unit out of the reach of children dur-
ing operation.
• Do not wash the motor unit under tapping
water (A), do not immerse into water or
other liquids: motor unit (A), whisk reduc-
tion unit (E), Chopper reduction unit (G).
• The unit corresponds to the safety stand-
ards. Repair and cord replacement of the
unit should be performed only by quali-
fied service personnel of the authorized
center. Otherwise, it can cause serious
injuries.
• This unit is intended for processing stand-
1465.indd 4 1465.indd 4
ard amounts of food, usually cooked at
home.
• Measuring cap (D) and mini-chopper
bowl (I) are not intended for usage in a
microwave oven.
Important information
This unit is not intended for professional
cooking. Time of continuous operation
should not exceed 1 minute, and then you
should make 5 minutes intervals.
Failure to comply with these time intervals
may lead to the damage of the motor unit.
Usage of the blender
Blender suits for cooking of sauces, soups,
mayonnaises, baby food and for blending
drinks and cocktails.
Operating speed selection
Use the speed control (L) to set the required
rotating speed of the attachments accord-
ing to the products being processed. The
higher the speed is, the quicker the rotation
is.
Assembly
WARNING: Before assembling the unit,
make sure that the plug is not inserted into
the socket.
1. Before using the unit for the first time,
wipe the motor unit (А), whisk reduction
unit (Е), chopper reduction unit (G) with
a damp cloth, and wash the attachments
with warm soapy water, rinse and dry.
2. Set the attachment (С), matching the
arrows on the attachment and on the
body of the blender (pic.А), and turn
the attachment anti-clockwise until it is
locked.
3. Insert the plug into the socket. The
blender is ready for operation.
4. Use the speed control (L) to set the re-
quired rotating speed.
5. Drop the attachment into the products
to blender; press the power switch (В) to
switch on the unit.
4
03.11.2010 10:03:19 03.11.2010 10:03:19