Technical Data - RIKA SONO AH Montageanleitung

ENGLISH

16. TECHNICAL DATA

Dimensions of SONO AH
B
Dimensions
Height
Width
Corpus depth
Weight
Weight with steel cover
Weight with stones
Flue pipe connection
R - Ø Flue pipe outlet
RO - H connection height
RO - T1 original angle pipe total depth
RO - T2 original angle pipe distance to
rear wall
RO - T3 Depth from rear wall to middle of
flue pipe
RO - S original angle pipe side distance
R - H rear connection height
R - S rear connection side distance
Fresh air connection
F - Ø Diameter
F - H Connection height
F - S Side distance
Convection Air Connection
K - Ø Diameter
K - H Connection Height
K - S Side Distance
Amount of Fuel
Amount of fuel
Burn time at full pellet hopper
*Practical values may vary depending on pellet quality.
Note
Pellet consumption depends on the size of the pellets. The larger
the pellets, the slower the feed and vice versa.
(AH) - rear flue pipe connection
T F-S R-S
K1-S
AH
[mm] 1050
[mm] 690
[mm] 385
[kg] ~
[kg] ~
[mm]
[cm]
[cm]
[cm]
[cm]
[cm]
[cm]
[cm]
[mm]
[cm]
[cm]
[mm]
[cm]
[cm]
Nominal
Part load
load
~ , kg* ~ , kg*
~14h* ~40h*
Technical data for SONO AH
Technical data
Heating power range
Room heating capacity (depending
on house insulation)
Fuel consumption
Pellet container capacity*
Electric supply
Average electrical input
Fuse
Efficiency
CO
2
CO-emission on 13% OO
Dust emission
Exhaust
Exhaust temperature
Chimney draft requirement
*The capacity in kg may deviate due to different pellet bulk
densities.
The owner of small firing systems or the person authorised for the
-
small firing system is to keep the technical documentation and is to
submit it to the authorities or the chimney sweep on request.
-
Note
-
Please observe the national and European standards as well as
local regulations concerning the installation and operation of
-
firing installations!
-
Packaging
Your first impression is important to us!
The packaging of your new stove provides excellent protection
against damage. However damage to the stove and accessories
may still occur during transport.
Note
Therefore please check your stove on receipt for damage and
completeness! Report any deficiencies to your dealer immediately!
Pay particular attention during unpacking that the stone panels
remain intact. Scratches to the material can easily occur. Stone
panels are excluded from the warrant.
The packaging of your new stove is environmentally neutral to a
great extent.
Tip
The wood used in the packaging has not been surface treated.
The cardboard and film (PE) can be disposed of via the municipal
waste collection for recycling.
Electrical connection
The stove is supplied with an approx. 2m long connecting cable with
a Euro-plug. This cable is to be connected to a 230Volt/50Hz socket.
The average electrical power consumption is some 20 Watt in
heating operation. And approx. 150 Watt during automatic ignition.
The connection cable must be laid so that there is no contact to any
sharp edges or hot surfaces of the stove.
[kW]
[m ]
[kg/h]
[l]/[~kg]
[V]/[Hz]
[W]
[A]
[%]
[%]
[mg/m ]
2 N
[mg/m ]
N
[g/s]
[°C]
[Pa]
, -
-
till ,
/~
/
~
, AT
testing
testing
testing
|31
30