Infrared Remote Control - Chauvet DJ GigBAR MOVE Bedienungsanleitung

IRC-6 Infrared Remote Control
The GigBAR MOVE can be operated with the CHAUVET IRC-6. To enable IR wireless control, follow the
instructions below.
1. Press <MENU> to view the main menu on the display.
2. Use <UP> or <DOWN> until SYS is selected.
3. Press <ENTER>.
4. Use <UP> or <DOWN> until IR is selected.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select ON.
7. Press <ENTER>.
IRC-6 Operation
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode with the IRC-6:
BLACK
AUTO SOUND
OUT
SENSI-
STROBE SPEED
TIVITY
Speed
% To adjust the auto program speed with the IRC-6:
MANUAL FADE
R G B
Sound-Active Mode
A UV W
To turn on Sound-Active mode with the IRC-6:
+ -
0
1 2 3
To adjust the sound sensitivity:
4 5 6
7 8 9
Manual Color Control
To choose a specific color for the Pars and Derby Lights with the IRC-6:
To manually control the RGB percentage:
Black Out
To black out the lasers with the IRC-6:
This will turn off all the lasers until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
product does not respond when a button is pressed, try pressing <BLACK OUT>.
Black Out may have been activated.
• Any setting on the IRC-6 will be saved until the system is rebooted. The system will
revert to Auto Mode after reboot.
• The buttons on the IRC-6 not listed above are reserved for future use.
Page 22
1. Press and hold <AUTO> on the IRC-6.
2. Press <+> or <–> to choose between the different auto programs.
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the program speed.
1. Press and hold <SOUND> on the IRC-6.
2. Press <+> or <–> to select a sound-active program.
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to increase or decrease the sensitivity.
• Press any number between <0>–<9> to choose your color.
1. Press <R> (red), <G> (green), <B> (blue), <A> (amber), <UV> (UV), or
<W> (white) to choose your color.
2. Press <+> or <–> to increase or decrease the percentage of each color.
• Press <BLACK OUT> on the IRC-6.
Operation
GigBAR MOVE User Manual Rev. 3