Dmx Linking; Infrared Remote Control) - Chauvet DJ Intimidator Hybrid 140SR V2 Schnellanleitung

Main Level
Lamp
Setting
Setup
(cont.)
Special Set
Sys Info

DMX Linking

The Intimidator Hybrid 140SR V2 can work with a DMX controller. Instructions for connecting and configuring this product for
DMX operation are in the User Manual. If you are not familiar with DMX, download the DMX Primer from www.chauvetdj.com.
Starting Address
To ensure full access to all channels available in each DMX mode, the highest recommended DMX address is 494.
Master/Slave Connection
The Intimidator Hybrid 140SR V2 uses the DMX data connection for its Master/Slave mode. Information about configuring
the Intimidator Beam 140SR for Master/Slave operation is in the User Manual, which is available from the Chauvet
website.
IRC-6 (Infrared Remote Control)
The Intimidator Hybrid 140SR V2 can be operated with the CHAUVET IRC-6. For more information about the IRC-6,
download instructions for the IRC-6 or the Intimidator Beam 140SR User Manual from www.chauvetdj.com.
Intimidator Hybrid 140SR V2 QRG Rev. 2
QUICK REFERENCE GUIDE
Programming Levels
On/Off
State/Power
On
Off Via DMX
On If DMX On
Off If DMX Off
Ignition Delay
Low Power
Delay
Reset Lamp
Time
Lamp Power
Interval
Remain Time
Reset
Factory Set
Ver:
Running Mode
DMX Address
Lamp On Time
Remain Time
Description
OFF
Turns lamp on or off
ON
OFF
Defines the status of lamp when powering up product
ON
NO
Allows the lamp to be turned off through DMX
YES
NO
Turns lamp on when DMX signal is detected
YES
NO
Turns lamp off when DMX signal is lost
YES
Selects duration of delay between product powering
000–255
on and lamp turning on
Selects the duration of delay between shutter closing
000–255
and lamp enters low power mode
NO
Resets lamp time counter (for when lamp is replaced)
YES
132 Select if installed lamp is 132 W Osram HRI
140 Select if installed lamp is 140 W Osram HRI
10–250 Defines number of hours between maintenance
NO
Resets maintenance timer
RESET
Resets the product
Loads factory defaults
V_ Displays the software version
_ _ _ _ _ _ _ Displays the current running mode
_ _ _ Displays the current DMX address
_ _ _ _ _ Displays how long the lamp has been running
_ _ _ _ _ Shows amount of time remaining in maintenance cycle
EN
4