Unpacking Instruction; Power Supply; Rear Panel - Fenton SBS65 Bedienungsanleitung

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

REAR PANEL

1. AUX INPUT
3.5mm Stereo jack can be used to
connect a CD player, MP3player,
smartphone and other audio sources.
2. USB PORT
USB entry port.
3. INPUT
Press to switch input channel.
4. PREV
Skip to previous track.
5. PLAY / PAUSE
Start or pause play by pressing this
button.
6. NEXT
Skip to next track.
7. SD CARD SLOT
Insert an SD card in this slot.
8. MIC VOL -
Lower MIC volume.
9. MIC VOL +
Raise MIC volume.
10. IR
Remote control signal receiver.
11. VOLUME
Turn to adjust the volume to the
desired level.
12. 5V DC INPUT
Adapter input 5V/2A.
13. MIC INPUT
6.35mm (1/4") jack input for
microphone.
14. LED LIGHT ON/OFF
Turn the LED light effect ON/OFF.
4